- 您现在的位置：买卖IC网 > Sheet目录299 > 71M6545-IGT/F (Maxim Integrated)IC ENERGY METERING
71M6545/71M6545H Data Sheet
3
3.1
FUNCTIONAL DESCRIPTION
Theory of Operation
The energy delivered by a power source into a load can be expressed as:
t
E = ∫ V ( t ) I ( t ) dt
0
Assuming phase angles are constant, the following formulae apply:
?
?
P = Real Energy [Wh] = V * A * cos φ* t
Q = Reactive Energy [VARh] = V * A * sin φ * t
?
S = Apparent Energy [VAh] =
P 2 + Q 2
For a practical meter, not only voltage and current amplitudes, but also phase angles and harmonic
content may change constantly. Thus, simple RMS measurements are inherently inaccurate. A modern
solid-state electricity meter IC such as the 71M6545/H functions by emulating the integral operation
above, i.e. it processes current and voltage samples through an ADC at a constant frequency. As long as
the ADC resolution is high enough and the sample frequency is beyond the harmonic range of interest,
the current and voltage samples, multiplied with the time period of sampling yields an accurate quantity
for the momentary energy. Summing-up the momentary energy quantities over time results in
accumulated energy.
500
400
300
200
100
0
0
5
10
15
20
-100
-200
-300
-400
Current [A]
Voltage [V]
Energy per Interval [Ws]
Accumulated Energy [Ws]
-500
Figure 21: Voltage, Current, Momentary and Accumulated Energy
Figure 21 shows the shapes of V(t), I(t), the momentary power and the accumulated power, resulting from
50 samples of the voltage and current signals over a period of 20 ms. The application of 240 VAC and
100 A results in an accumulation of 480 Ws (= 0.133 Wh) over the 20 ms period, as indicated by the
accumulated power curve. The described sampling method works reliably, even in the presence of dynamic
phase shift and harmonic distortion.
3.2
SLP Mode (Sleep Mode)
Shortly after system power (V3P3SYS) is applied, the part will be in mission mode (MSN mode). MSN
mode means that the part is operating with system power and that the internal PLL is stable. This mode
is the normal operation mode where the part is capable of measuring energy.
66
v2
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
720-10007-00300
CBL D-SUB 9PIN FMAL-25PIN FML 3M
720-10010-00025
CBL DSUB 9PIN FML-25PIN MAL .25M
720-10020-00300
CBL DSUB 9PIN FML-9PIN MALE 3M
720-10021-00300
CBL DSUB 9PIN FML-9PIN FEMAL 3M
72231-0881
8 POS T/P SHLD 4 GR ASSY
7250B
PANEL KIT BOTTOM FOR R-1220 CASE
731-10061-00200
CBL DSUB HD 15FEMAL-15MALE 2.0M
73304-111
MJ HOR ESMT 8/8 H/O T&R
相关代理商/技术参数
71M6545-IGTR/F
功能描述:计量片上系统 - SoC Metrology Proc. (3P 64K Flsh .1%)
RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6545T-IGT/F
制造商:Maxim Integrated Products 功能描述:METROLOGY PROCESSORS - Rail/Tube
71M6545T-IGTR/F
制造商:Maxim Integrated Products 功能描述:3-PHASE AFE, 32KB FLASH, PRES TEMP SENSOR - Tape and Reel
71M6601
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:On-Chip Temperature Sensor Enables Localized Digital Temperature On-Chip Power Monitoring
71M6601-IF
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:On-Chip Temperature Sensor Enables Localized Digital Temperature On-Chip Power Monitoring
71M6601-IL
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:On-Chip Temperature Sensor Enables Localized Digital Temperature On-Chip Power Monitoring
71M6601-IL/F
功能描述:模数转换器 - ADC Isolated Sensor IC
RoHS:否 制造商:Texas Instruments 通道数量:2 结构:Sigma-Delta 转换速率:125 SPs to 8 KSPs 分辨率:24 bit 输入类型:Differential 信噪比:107 dB 接口类型:SPI 工作电源电压:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-32
71M6601-ILF
制造商:MAXIM 制造商全称:Maxim Integrated Products 功能描述:On-Chip Temperature Sensor Enables Localized Digital Temperature On-Chip Power Monitoring